FF300 FaultFinder

Applications

No Ground or clip required
Operates on DC voltages from 6 to 36 volts
Internally protected against power surges and overloads
9″ flexible probe allows reaching wires in congested places
Transmitter and Receiver LEDs show open or short circuit conditions
Variable audio/visual signal provides fast and intuitive feedback on the circuit/wire proximity
Adjustable sensitivity for all tracing situations
No wire piercing required, non-contact technology!
Tracing of wires is made possible even inside bundles, conduits, behind panels, under carpets, upholstery, etc.
Transmitter has auto polarity and leads with 5 amps alligator clips

Indicators: Green LED for power On and Open circuits. Red LED for short circuits
Power source: 9-volt alkaline battery. Duracell type MN1604 (included)
Battery life: approx. 50 hrs
Connector: Two 5 A alligator clamps with auto polarity and 18″ long cable
Physical dimensions: 4.375″ (H) x 2.56″ (W) x 0.937″ (D) – (111 x 65 x 23 mm) – Excluding cable and probes
Weight: Approximately 5.6 Oz ( 156 g) Including battery

Sensitivity: Three user selectable sensitivity levels (low, medium and high)
Receiver probe: Flexible 9″ gooseneck insulated steel probe
Indicators: Green LED indicator for power on and open circuits. Red LED indicator for short circuits
Variable flashing and modulated audible signal
Power source: Standard 9-volt alkaline battery. Duracell type MN1604 (included)
Battery Life: approx. 50 hrs. Auto Power Off
Physical dimensions: 4.375″ (H) x 2.56″ (W) x 0.937″ (D) – (111 x 65 x 23 mm) – Excluding antenna and probe
Weight:Approximately 5.2 Oz ( 145 g) Including battery